Nationwide delivery

Nationwide delivery

Nationwide delivery

Specialist advice

Nationwide delivery

Best practices

Nationwide delivery

Secure checkout

Loading...

Isomass Isocheck Re-Mat Base 10 Acoustic Screed Underlay 1mtr x 6mtr x 10mm

£60.00 £50.00
POA
Product code:
IMICRMB10
Brand:
Isomass
Shopping Truck

3 -5 working days

Shipping costs displayed in basket

Isomass Isocheck Re-Mat Base 10 Acoustic Screed Underlay 1mtr x 6mtr x 10mm is available to buy in increments of 1
Ask a question about this product
Product Information
Data Sheets
Delivery Information
Reviews

The Isocheck Re-Mat Base 10 under screed impact improvement systems are designed to reduce impact sound transmission through all types of structural concrete floors where a screed floor finish is also required. If installed correctly provides sufficient impact absorption to place it amongst the top performing systems available.

Isocheck Re-Mat Base 10 comprises 10mm (for high load) reconstituted bonded rubber layer that has been designed to be placed within a masonry structural floor directly below the screed. Isocheck Re-Mat Base 10 have been tested to BS EN 29052-1:1992 and satisfy the dynamic stiffness requirement with a figure of 10MN/m3.

 

Benefits

  • Tested as a single 6mm layer.
  • Composition prevents water transmission which can impair acoustic performance.

 

Application & Installation

  • The floor surface should be swept free of any loose debris that may damage or bridge the system.
  • Butt joint and seal all roll edges of isocheck Re-Mat Base 10. At perimeters overlap Re-Mat Base 10 onto a right-angle flanking edge strip which should be turned up all vertical surfaces to allow a minimum 50mm to protrude above the intended FFL of the screed.
  • Perimeter overlaps or butt joints should be sealed with a min 100mm wide duct tape.
  • Services that penetrate the screed should be isolated by wrapping with Re-Mat Base 10 which again would be taped.
  • When trafficking the floor take care not to perform any unnecessary actions that may cause any of the taped joints to be forced apart.

 

  

Properties
Thickness: 10mm
Length: 6m
Width: 1.25m
Coverage: 7.5m²
Composition: Bonded rubber fibres
Density: 730kg/m³ ±5%
Thermal Conductivity: 0.14 W/mK

 

Isomass Isocheck Re-Mat Base Acoustic Sreed is also available in the following sizes:
Products Link to products:
Base3 (1mx10mx3mm) Click here
Base10 (1mx6mx10mm) Click here

 

 

 

Data Sheet

For delivery information, please refer to our delivery policy page.

Write Your Own Review
You're reviewing:Isomass Isocheck Re-Mat Base 10 Acoustic Screed Underlay 1mtr x 6mtr x 10mm
Product Information

The Isocheck Re-Mat Base 10 under screed impact improvement systems are designed to reduce impact sound transmission through all types of structural concrete floors where a screed floor finish is also required. If installed correctly provides sufficient impact absorption to place it amongst the top performing systems available.

Isocheck Re-Mat Base 10 comprises 10mm (for high load) reconstituted bonded rubber layer that has been designed to be placed within a masonry structural floor directly below the screed. Isocheck Re-Mat Base 10 have been tested to BS EN 29052-1:1992 and satisfy the dynamic stiffness requirement with a figure of 10MN/m3.

 

Benefits

  • Tested as a single 6mm layer.
  • Composition prevents water transmission which can impair acoustic performance.

 

Application & Installation

  • The floor surface should be swept free of any loose debris that may damage or bridge the system.
  • Butt joint and seal all roll edges of isocheck Re-Mat Base 10. At perimeters overlap Re-Mat Base 10 onto a right-angle flanking edge strip which should be turned up all vertical surfaces to allow a minimum 50mm to protrude above the intended FFL of the screed.
  • Perimeter overlaps or butt joints should be sealed with a min 100mm wide duct tape.
  • Services that penetrate the screed should be isolated by wrapping with Re-Mat Base 10 which again would be taped.
  • When trafficking the floor take care not to perform any unnecessary actions that may cause any of the taped joints to be forced apart.

 

  

Properties
Thickness: 10mm
Length: 6m
Width: 1.25m
Coverage: 7.5m²
Composition: Bonded rubber fibres
Density: 730kg/m³ ±5%
Thermal Conductivity: 0.14 W/mK

 

Isomass Isocheck Re-Mat Base Acoustic Sreed is also available in the following sizes:
Products Link to products:
Base3 (1mx10mx3mm) Click here
Base10 (1mx6mx10mm) Click here

 

 

Data Sheets

 

Data Sheet

Delivery Information

For delivery information, please refer to our delivery policy page.

Reviews
Write Your Own Review
You're reviewing:Isomass Isocheck Re-Mat Base 10 Acoustic Screed Underlay 1mtr x 6mtr x 10mm
 

Have a question about this product?