The Isocheck Re-Mat Base 3 under screed impact improvement systems are designed to reduce impact sound transmission through all types of structural concrete floors where a screed floor finish is also required. If installed correctly provides sufficient impact absorption to place it amongst the top performing systems available.
Isocheck Re-Mat Base 3 comprises 3mm (for high load) reconstituted bonded rubber layer that has been designed to be placed within a masonry structural floor directly below the screed. Isocheck Re-Mat Base 3 have been tested to BS EN 29052-1:1992 and satisfy the dynamic stiffness requirement with a figure of 10MN/m3.
Benefits
Tested as a single 6mm layer.
Composition prevents water transmission which can impair acoustic performance.
Application & Installation
The floor surface should be swept free of any loose debris that may damage or bridge the system.
Butt joint and seal all roll edges of isocheck Re-Mat Base 3. At perimeters overlap Re-Mat Base 3 onto a right-angle flanking edge strip which should be turned up all vertical surfaces to allow a minimum 50mm to protrude above the intended FFL of the screed.
Perimeter overlaps or butt joints should be sealed with a min 100mm wide duct tape.
Services that penetrate the screed should be isolated by wrapping with Re-Mat Base 3 which again would be taped.
When trafficking the floor take care not to perform any unnecessary actions that may cause any of the taped joints to be forced apart.
Properties
Thickness:
3mm
Length:
20m
Width:
1m
Coverage:
20m²
Composition:
Bonded rubber fibres
Density:
730kg/m³ ±5%
Thermal Conductivity:
0.14 W/mK
Isomass Isocheck Re-Mat Base Acoustic Sreed is also available in the following sizes:
The Isocheck Re-Mat Base 3 under screed impact improvement systems are designed to reduce impact sound transmission through all types of structural concrete floors where a screed floor finish is also required. If installed correctly provides sufficient impact absorption to place it amongst the top performing systems available.
Isocheck Re-Mat Base 3 comprises 3mm (for high load) reconstituted bonded rubber layer that has been designed to be placed within a masonry structural floor directly below the screed. Isocheck Re-Mat Base 3 have been tested to BS EN 29052-1:1992 and satisfy the dynamic stiffness requirement with a figure of 10MN/m3.
Benefits
Tested as a single 6mm layer.
Composition prevents water transmission which can impair acoustic performance.
Application & Installation
The floor surface should be swept free of any loose debris that may damage or bridge the system.
Butt joint and seal all roll edges of isocheck Re-Mat Base 3. At perimeters overlap Re-Mat Base 3 onto a right-angle flanking edge strip which should be turned up all vertical surfaces to allow a minimum 50mm to protrude above the intended FFL of the screed.
Perimeter overlaps or butt joints should be sealed with a min 100mm wide duct tape.
Services that penetrate the screed should be isolated by wrapping with Re-Mat Base 3 which again would be taped.
When trafficking the floor take care not to perform any unnecessary actions that may cause any of the taped joints to be forced apart.
Properties
Thickness:
3mm
Length:
20m
Width:
1m
Coverage:
20m²
Composition:
Bonded rubber fibres
Density:
730kg/m³ ±5%
Thermal Conductivity:
0.14 W/mK
Isomass Isocheck Re-Mat Base Acoustic Sreed is also available in the following sizes: